This brand name represents the top quality for
our high precision standard tools.
For high speed machines, SilverRex^®-Alu with
a special heat treatment is the optimum  
solution. 

The Chromex type of blade is recommended
for the cutting of non-ferrous materials.
Metal Cutting Circular Saw Blades with a
special chrome-nitride coating are supplied to
work on tough materials.
Slitting saws made of HSS/E (EMo5Co5) are
sold under the brand name SilverRex^®-Co.

SilverRex^® a registered brand name of the OTT+HEUGEL company

TuboRex^® are high precision HSS saw blades
with minimum side run-out are used with a  
special surface treatment. 

The cutting geometry is based on using the
correct tooth pitch for the particular tube
wall thickness as well as a properly rounded
tooth gullet.

TuboRex® saw blades are provided with staggered chip breaker grooves ground into blades periphery using a borazon grinding wheel. This grind results on each pair of teeth breaking up the chip into four parts. These small chips are easily washed away by the coolant stream or spray mist.
TuboRex® a registered brand name of the OTT+HEUGEL company

Solid Carbide Blades are used for the heavy
duty sawing of tough materials or for the
increasing of the tool life. These wear-resisting
tools are set on high precision machines that
work without any vibration and a rigid clamping
of the material is assured. Therefore the
requirements for these high precision tools are
tightest tolerances for high cutting speeds and
feeds, better tool life, and sharp cutting edges.
The high precision and mirror finish of these
blades guarantees a super cut surface which
normally does not require any further finish
operations.
The cutting speeds and feeds of CARBODUR^®
blades are approximately five times higher than  
blades made of HSS - the tool life is ten times  
compared to HSS-tools. 

If standard tools are no longer capable of
producing chips, CARBODUR^® Saw Blades with 
hard wear resistant coatings (TIN, TiCN or 
TiAIN) are often still able to cut the material.  
The combination - Solid Carbide Blades plus a  
coating - is the utmost solution to get the best  
wear and temperature resistance, and hardness. 

CARBODUR^® a registered brand name of the OTT+HEUGEL company